Flint and Steel Fire-making

872fbd2789ee10067094a672e8b206ae

Flint and Steel Fire-making

Flint and steel is a primitive fire-making technique dating back into the Iron Age when steel was first available for this simple and quite effective way to ignite fire. It frequently was used until recently, when matches were invented, making the flint and steel method obsolete. Yet there are many reasons why flint and steel should still be considered an important and reliable means of fire ignition by all outdoors enthusiasts. The materials resist moisture, and the method uses simple and easily replicable parts. Flint and steel fire-making is an efficient method with the right amount of practice.

Creating Your Flint and Steel Fire Kit

There are four parts to this kit: steel striker, flint, char-cloth and tinder bundle. The pieces work like this: the steel striker is glanced off the sharp edge of the steel. This sheds heated pieces of steel – in the form of sparks – off of the striker. These sparks ignite the char-cloth, which smolders and is placed into the tinder bundle, to be blown into flame. This all takes only a matter of seconds with experience and a well-put-together kit.

These materials are very easy to come by and make. The steel striker is a piece of high-carbon steel, formed into an elongated oval, with a gap along one of the sides. This allows the user to hold it with the complete side over the knuckles of his or her dominant hand and the gapped side clenched in the fist. This makes for a very efficient and accurate motion for striking the flint.

How to Use Flint and Steel

Traditionally, the flint is as described, a piece of this extremely hard rock. There are alternatives, however, and any very hard stone will work. Examples are quartzite and chert, both easily found throughout most of the United States. The piece should be sturdy, a quarter-inch to half-inch thick, with a sharp, acute edge that will shear away pieces of the steel. This edge occasionally has to be touched up – using pressure flaking – to regain its sharpness. At some point, after enough mass from the flint is removed, the piece is discarded for a new flake of sharp stone. The sharp edge is essential! The steel strikes the edge of the flint, which is pinched between the thumb and index finger of your other hand, at a 90-degree angle as it travels in and down across this sharp edge, shedding sparks downward.

These sparks are caught in the char-cloth, an essential part of this system. Char-cloth is essentially a thin piece of charcoal, produced by exposing cotton cloth to heat in the absence of oxygen. This is easily made by enclosing small swatches of denim, terry-cloth, or knit cotton cloth in a small tin can (Altoid cans work very well). It is important that the cloth you choose be made of a natural fiber and not synthetic. Poke a hole in the lid of the tin with an awl to allow vapors to escape in the firing process, otherwise the lid will pop off and expose the burning cloth to oxygen. Once the tin is packed loosely, place it in a fire and heat it until the smoke coming from the hole ceases. Set the can aside to cool over night. In the morning, you will discover that the cloth has turned black and is somewhat brittle. This is char-cloth.

There are two styles of catching the sparks in the char-cloth. One way is the place a piece of cloth on a flat surface and strike above it, allowing the sparks to drop down and catch on fire. I personally find this method unreliable, as the sparks are sometimes hard to direct and the cloth can be damaged with a wayward strike. The second method is to fold the char-cloth over the edge of the flint, held in place by the two fingers pinching the flint. The flint is then struck through the cloth, with the sparks inevitably catching in the cloth that is blocking their descent.

Leave a Reply

Your email address will not be published. Required fields are marked *